Command_Qualifiers

 

/IMAGE_FILE
      /IMAGE_FILE=file-spec
      /NOIMAGE_FILE

   By default, CNBUILD creates as output the file PMDF_CONFIG_DATA.
   With the /IMAGE_FILE qualifier, an alternate file name may be
   specified.

   When the /NOIMAGE_FILE qualifier is specified, CNBUILD does not
   produce an output file. This qualifier is used in conjunction
   with the /OPTION_FILE qualifier to produce as output an
   option file which specifies table sizes adequate to hold the
   configuration required by the processed input files.
 

/MAXIMUM
      /MAXIMUM
      /NOMAXIMUM (default)

   The file PMDF_TABLE:MAXIMUM.DAT is read in addition to PMDF_
   OPTION_FILE when /MAXIMUM is specified. This file specifies near
   maximum table sizes but does not change any other option file
   parameter settings. Only use this qualifier if the current table
   sizes are inadequate. The /NOIMAGE and /OPTION_FILE qualifiers
   should always be used in conjunction with this qualifier-it makes
   no sense to output the enormous configuration that is produced by
   /MAXIMUM, but it does make sense to use /MAXIMUM to get past
   size restrictions in order to build a properly sized option
   file so that a properly sized configuration can be built with
   a subsequent CNBUILD invocation.
 

/OPTION_FILE
      /OPTION_FILE[=file-spec]
      /NOOPTION_FILE (default)

   CNBUILD can optionally produce an option file that contains
   correct table sizes to hold the configuration that was just
   compiled (plus a little room for growth). The /OPTION_FILE
   qualifier causes this file to be output. By default, this file
   is the file pointed to by the PMDF_OPTION_FILE logical, normally
   PMDF_TABLE:OPTION.DAT. The value on the /OPTION_FILE qualifier
   may be used to specify an alternate file name. If the /NOOPTION_
   FILE qualifier is given, then no option file will be output.

   CNBUILD always reads any option file that is already present
   via the PMDF_OPTION_FILE logical name; use of this qualifier
   will not alter this behavior. However, use of the /MAXIMUM
   qualifier causes CNBUILD to read PMDF options from the PMDF_
   TABLE:MAXIMUM.DAT in addition to reading PMDF_OPTION_FILE. This
   file specifies near maximum table sizes. Only use this qualifier
   if the current table sizes are inadequate, and only use it to
   create a new option file. The /NOIMAGE qualifier should always be
   specified when /MAXIMUM is specified since a maximum-size image
   would be truly enormous and extremely wasteful.
 

/SIZES
      /SIZES
      /NOSIZES (default)

   The /SIZES qualifier instructs PMDF CNBUILD to output information
   on the sizes of the elements of the uncompiled configuration.
 

/STATISTICS
      /STATISTICS
      /NOSTATISTICS (default)

   The /STATISTICS qualifier instructs CNBUILD to output information
   on how much of the various tables in the compiled configuration
   were actually used to store data. These numbers give a rough
   measurement of the efficiency of the compilation, and may
   indicate whether or not an additional rebuild with the /OPTION_
   FILE qualifier is needed.