NCPHELP.HLB  —  LOAD  NODE
 Use the LOAD NODE command to downline load software to a target  node.
 This  command  loads  the  software either via the identified circuit (if
 specified) or via the circuit obtained from the volatile database.   Any
 parameter  left  unspecified in the command defaults to whatever entry
 is specified in the volatile database on the executor node.

 LOAD    NODE node-id    (parameters ...)

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.
Additional Information: explode extract
ADDRESS node-address CPU FROM file-spec HOST node-id LOAD MANAGEMENT FILE NAME node-name PHYSICAL ADDRESS address SECONDARY LOADER file-spec SERVICE SOFTWARE TERTIARY LOADER file-spec VIA circuit-id Examples
Close Help