VMS Help  —  PMDF  POPSTORE  GROUP  Command Qualifiers

1    /ADD 

    This qualifier indicates that a new management group is to be
    added. If a group already exists with the same name, then an
    error will be output.

2    /CONFIRM 

       /CONFIRM
       /NOCONFIRM (default)

    Prompt for positive confirmation before carrying out the
    indicated operation. /NOCONFIRM is the default behavior.

3    /DELETE 

    This qualifier indicates that the specified management group
    is to be deleted. Note that subgroups contained within the
    group are not deleted by default. Specify /RECUR to also
    delete any subgroups. Moreover, the actual accounts in the
    group are not deleted either. They can only be deleted with a
    DELETE/GROUP=GROUP_NAME * command.

4    /FORMAT_FILE 

       /FORMAT_FILE=file-spec

    Specify a formatting file to use to format the output of
    GROUP/LIST command.

5    /LIST 

    List the specified groups and subgroups. When this qualifier is
    used, the GROUP-NAME parameter can contain wild card characters.
    When the parameter is omitted, * is assumed.

6    /LOG 

       /LOG
       /NOLOG (default)

    When the operation is successful, output a status message stating
    that the operation succeeded. Note that error messages are always
    indicated. /NOLOG is the default behavior.

7    /MODIFY 

    Modify the specified group, replacing its list of subgroups with
    the specified list. If no list is specified, then the group is
    changed to contain no subgroups.

8    /OUTPUT 

       /OUTPUT=file-spec

    Write the output to the specified file rather than to the
    terminal.

9    /PROMPT 

       /PROMPT (default)
       /NOPROMPT

    By default if a wildcard is used, even if /NOCONFIRM is
    specified, one confirmation prompt is issued. If /NOPROMPT is
    specified, there is no prompting at all. This qualifier can be
    used in conjunction with the /ADD, /DELETE, or /MODIFY switches.

10    /RECUR 

       /RECUR
       /NORECUR (default)

    This qualifier can be used in conjunction with /DELETE. By
    default, only the specified group is deleted. Subgroups of that
    group are not deleted unless /RECUR is also specified.
Close Help