1  SET
 

2  AUTO
   Changes the setting of auto-load, auto-perm, or exclude and
   include lists. When used with no qualifiers, this command causes
   the UCM server to reload the saved settings from disk.

                                  NOTE

      Once a device is made a permanent device, it is always
      configured and loaded, regardless of the settings for SET
      AUTO. To remove a permanent device, you must use the DELETE
      DEVICE command.

   Format

     SET AUTO
 

3  Qualifiers
 

/ENABLE

      /ENABLE=(LOAD,PERM)
   /DISABLE=(LOAD,PERM)

   The /ENABLE and /DISABLE qualifiers allow you to disable or
   selectively enable automatic loading and automatic permanence
   for all non-permanent devices. The two qualifiers have these
   meanings:

   Qualifier  Explanation

   /ENABLE    Allows you to selectively enable automatic loading
              permanence. Automatic permanence is ignored if
              automatic loading is disabled. However, you can enable
              automatic loading and disable automatic permanence.
              This allows devices to be configured but does not
              add them to the permanent database. Also, the OpenVMS
              device name cannot be persistent.
   /DISABLE   Allows you to disable device loading on a per-device
              basis.

   Explanations of the keywords LOAD and PERM are in the following
   table:

   KeyworTerm             Explanation

   LOAD  Automatic        Allows the device to be automatically
         loading          configured-that is, the device driver is
                          loaded and an OpenVMS device is created
                          for it.
   PERM  Automatic        Causes the UCM to add the device to the
         permanence       permanent database. Once a device is added
                          to the permanent database, each time it
                          is connected to the system it will have
                          the driver loaded and the device name will
                          always remain the same-that is, it will be
                          persistent.

   By default, automatic loading (LOAD) and automatic permanence
   (PERM) are enabled. Automatic permanence is ignored if automatic
   loading is disabled. However, you can enable automatic loading
   and disable automatic permanence. This allows devices to be
   configured but does not add them to the permanent database. (The
   OpenVMS device name might not be persistent in this case.)
 

/EXCLUDE

      /EXCLUDE=()
   /INCLUDE=()

   The EXCLUDE and INCLUDE qualifiers allow more explicit control
   over which devices will be automatically configured.

   You can give each qualifier one or more device names, or partial
   device names. When you provide a partial device name, the
   trailing characters are wildcarded. You can include an explicit
   "*" wildcard to indicate all devices.

   UCM examines the EXCLUDE list before automatically configuring
   a device that is not in the permanent database. If the device is
   on the EXCLUDE list, UCM examines the INCLUDE list to determine
   if the device is explicitly included for loading. This allows
   you to specify a broad range of devices in the EXCLUDE list and
   to specify a narrow set of devices in the INCLUDE list (see the
   following example).
 

3  Example

 $ UCM
 UCM> SET AUTO/EXCLUDE=*/INCLUDE=(tx,dn)
 UCM> SHOW AUTO



       AUTO LOAD ENABLED
       AUTO PERM ENABLED
       EXCLUDE = (*)
       INCLUDE = (TX, DN)

     In this example, all devices are excluded with the exception
     of TX and DN devices. A joystick using AGA0, for example, will
     not be configured, but a disk DNA0 will be configured, as will
     TXC2.
 

2  LOG
   Tells the configuration server to create a new log file. You must
   use the /NEW qualifier with this command.

   Requires OPER privilege.

   Format

     SET LOG  /NEW
 

3  Qualifier
 

/NEW

   Creates a new SYS$MANAGER:USB$UCM_EVENTS.DAT file. This qualifier
   is required with the SET LOG command.