The SHOW MODULE CONFIGURATOR command shows information about the
 Ethernet configurator module from the volatile database at the local
 node.  Use the LIST MODULE CONFIGURATOR command to display
 the information stored in the permanent database. Note,
 the word MODULE is optional.

   SHOW MODULE CONFIGURATOR  KNOWN CIRCUITS     CHARACTERISTICS TO file-id
   LIST                      CIRCUIT circuit-id STATUS
                                                SUMMARY

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

1  –  KNOWN CIRCUITS

 Applies only to Ethernet circuits.  Indicates the configurator
 information should be displayed for all known Ethernet circuits.

2  –  CIRCUIT

 Applies only to Ethernet circuits.  Indicates that configurator
 information should be displayed only for the Ethernet circuit
 identified by circuit-id.

3  –  CHARACTERISTICS

 Indicates that dynamic information on all active systems on the
 specified Ethernet circuit or circuits is to be displayed.
 (Characteristics and Status result in a similar display)

4  –  STATUS

 Indicates that dynamic information on all active systems on the
 specified Ethernet circuit or circuits is to be displayed.
 (Characteristics and Status result in a similar display)

5  –  SUMMARY

 Indicates that the only information to be displayed is the list of
 circuits being monitored and the length of time surveillance has
 been maintained.  This is the default type.

6  –  TO

 Specifies the output file.  If none is specified, SYS$OUTPUT is the
 default.