Use the SET MODULE X25-ACCESS and DEFINE MODULE X25-ACCESS commands
 to associate the host node with the specified multi-host node for the
 purpose of accessing a specified X25 network.  The multi-host node
 connected to the specified X25 network is a VMS node with VAX
 PSI multi-host software installed.

       SET    MODULE X25-ACCESS     NETWORK network-name     ACCOUNT
                                    KNOWN NETWORKS           ALL
                                                             NODE
                                                             PASSWORD
                                                             USER

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

1  –  ACCOUNT

 Identifies the user account for use by incoming calls to the
 network.  Specify a string of from 1 to 39 characters.  By
 default, no account is used.

2  –  ALL

 Copies all X25-ACCESS parameters from the permanent data base into
 the volatile data base.

3  –  KNOWN NETWORKS

 Identifies all known networks

4  –  NETWORK network-name

 Identifies the network whose parameters are to be set in the
 data base.

5  –  NODE node-id

 Specifies the node address or name used of the multi-host node that
 is connected to a specified X25 network.  When you specify an
 X25-ACCESS network for the first time, this parameter is mandatory.

6  –  PASSWORD

 Specifies the password for use by incoming calls to the network.
 Specify a string of from 1 to 39 characters.  The default is that no
 password is used.

7  –  USER

 Specifies the user identification for use by incoming calls to the
 network.  Specify a string of from 1 to 16 characters.  The
 default is that no user identification is used.