1  INTERRUPT
   Invokes an interrupt test.

2  GENERAL QUALIFIERS

/NODENAME

      /NODENAME=node-id

   Identifies the node (by name or address) on which DTR is to run. The
   default is the local node. DTR runs on the default nonprivileged
   account on the remote node because access control information cannot
   be used as part of the node name. To run DTR on an account other
   than the default, you must create a new account and associate it
   with the DTR object.   

/PRINT

      /PRINT
      /NOPRINT (D)

   Instructs DTS to print (or log) test results. The default is /NOPRINT.

/STATISTICS

      /STATISTICS (D)
      /NOSTATISTICS

   Instructs DTS to print statistics on data and interrupt tests. The
   default is /STATISTICS.

/DISPLAY

      /DISPLAY=number
      /NODISPLAY (D)

   Instructs DTS to print the specified number of bytes (in hexadecimal)
   of data and interrupt messages transmitted to DTR.  The default is
   /NODISPLAY.

/SPEED

	/SPEED=number

   Indicates the line speed (in Mbps) of the test line. DTS uses
   this qualifier for reporting statistics (DTS does not control line
   speeds). The default number is 100(100 Mbps).

   The allowable values are 10 , 100 , 1000 and 10000 for 10 Mbps , 100 Mbps,
   1 Gbps and 10 Gbps respectively.


2  COMMAND-SPECIFIC QUALIFIERS

/TYPE

      /TYPE=test-type

   Indicates the subtest for the interrupt test.  There are four subtests:

   SINK   Indicates a sink test. The default test type.
   SEQ    Indicates a sequence test.
   PAT    Indicates a pattern test.
   ECHO   Indicates an echo test.

/SIZE

      /SIZE=number

   Indicates the data message length in bytes. The lower bounds are 0 for
   a sink or echo test; 4 for a sequence test; and 5 for a pattern test.
   The upper bound is 16 bytes for all tests. The default size is 16.

/[TEST-DURATION]

      /[TEST-DURATION]

   Indicates the duration of the test. There are three units of time
   for this parameter:

      /SECONDS=number
      /MINUTES=number
      /HOURS=number

   The number specifies the duration of the test. The default unit is 
   /SECONDS=30. The maximum test duration is 3,600,000 seconds or 1000 hours.

2  Example

   _Test: INTERRUPT/NODENAME=apple/PRINT/TYPE=PAT/SIZE=16
   %NET-S-NORMAL, normal successful completion

   Test Parameters:
      Test duration (sec)  30
      Target node          "APPLE"
      Line speed (Mbps)    100
      Message size (bytes) 16

   Summary statistics:
      Total messages XMIT  166849  RECV 0
      Total bytes XMIT     2 MB
      Messages per second  5561.63
      Bytes per second     88 KBps
      Line thruput         711 Kbps
      %Line Utilization    0.712


   This command invokes the interrupt test with the pattern subtest. DTS
   sends interrupt messages to DTR on node DALLAS where test information
   is to be printed. The interrupt message size is 16 bytes, and the test
   is 30 seconds (by default).