Invokes an interrupt test.

1  –  GENERAL QUALIFIERS

1.1    /NODENAME

       /NODENAME=node-id

    Identifies the node (by name or address) on which DTR is to run. The
    default is the local node. DTR runs on the default nonprivileged
    account on the remote node because access control information cannot
    be used as part of the node name. To run DTR on an account other
    than the default, you must create a new account and associate it
    with the DTR object.

1.2    /PRINT

       /PRINT
       /NOPRINT (D)

    Instructs DTS to print (or log) test results. The default is /NOPRINT.

1.3    /STATISTICS

       /STATISTICS (D)
       /NOSTATISTICS

    Instructs DTS to print statistics on data and interrupt tests. The
    default is /STATISTICS.

1.4    /DISPLAY

       /DISPLAY=number
       /NODISPLAY (D)

    Instructs DTS to print the specified number of bytes (in hexadecimal)
    of data and interrupt messages transmitted to DTR.  The default is
    /NODISPLAY.

1.5    /SPEED

 	/SPEED=number

    Indicates the line speed (in Mbps) of the test line. DTS uses
    this qualifier for reporting statistics (DTS does not control line
    speeds). The default number is 100(100 Mbps).

    The allowable values are 10 , 100 , 1000 and 10000 for 10 Mbps , 100 Mbps,
    1 Gbps and 10 Gbps respectively.

2  –  COMMAND-SPECIFIC QUALIFIERS

2.1    /TYPE

       /TYPE=test-type

    Indicates the subtest for the interrupt test.  There are four subtests:

    SINK   Indicates a sink test. The default test type.
    SEQ    Indicates a sequence test.
    PAT    Indicates a pattern test.
    ECHO   Indicates an echo test.

2.2    /SIZE

       /SIZE=number

    Indicates the data message length in bytes. The lower bounds are 0 for
    a sink or echo test; 4 for a sequence test; and 5 for a pattern test.
    The upper bound is 16 bytes for all tests. The default size is 16.

2.3    /[TEST-DURATION]

       /[TEST-DURATION]

    Indicates the duration of the test. There are three units of time
    for this parameter:

       /SECONDS=number
       /MINUTES=number
       /HOURS=number

    The number specifies the duration of the test. The default unit is
    /SECONDS=30. The maximum test duration is 3,600,000 seconds or 1000 hours.

3  –  Example

    _Test: INTERRUPT/NODENAME=apple/PRINT/TYPE=PAT/SIZE=16
    %NET-S-NORMAL, normal successful completion

    Test Parameters:
       Test duration (sec)  30
       Target node          "APPLE"
       Line speed (Mbps)    100
       Message size (bytes) 16

    Summary statistics:
       Total messages XMIT  166849  RECV 0
       Total bytes XMIT     2 MB
       Messages per second  5561.63
       Bytes per second     88 KBps
       Line thruput         711 Kbps
       %Line Utilization    0.712

    This command invokes the interrupt test with the pattern subtest. DTS
    sends interrupt messages to DTR on node DALLAS where test information
    is to be printed. The interrupt message size is 16 bytes, and the test
    is 30 seconds (by default).