Use REPLACE to replace the contents of one or more locations with
 new  data in terms of the current mode settings.
 Before performing the replacement, the REPLACE  command  confirms
 the contents of the specified locations.

 Replacing Data:
 _________ _____
      When you replace ASCII or numeric data, the number of replacement
      entries cannot exceed the number of existing entries.  This means,
      for example, that if you confirm the contents of six consecutive
      locations, you can replace the contents of only those six locations.
      If the number of replacement entries is less than the number of
      existing entries, the remaining locations are filled with zeros.

      In addition, PATCH truncates replacement entries if  they  exceed
      the  limit imposed on them by the current length mode.  For ASCII
      characters, the right-most characters are discarded.  For numeric
      data, the left-most digits are discarded.

 Format:

      REPLACE location = current-contents [,...]
      new-contents
              .
              .
              .

           Mode Qualifiers                 Default
           ____ __________                 _______

           /BYTE
           /WORD                           /LONG
           /LONG

           /OCTAL
           /DECIMAL                        /HEXADECIMAL
           /HEXADECIMAL

           /[NO]ASCII                      /NOASCII

 Prompts:

 	LOC> location
 	OLD> current-contents
 	NEW> new-contents

1  –  Parameters

 location
      Specifies either (1) a single location whose contents are  to  be
      replaced  or  (2) the starting address of a sequence of locations
      whose contents are to be replaced.

 current-contents
      Specifies  one  or  more  data  entries  or  to  be replaced.
      The  data  you  specify must be the  actual contents.

      Do not specify conflicting data types  within  a  single  REPLACE
      command.

 new-contents
      Specifies one or more data entries or that are to replace the current
      contents.

      Do not specify conflicting data types  within  a  single  REPLACE
      command.